▎ 摘　　要

Electrochemical-reduced graphene oxide (ERGO) nanocomposites decorated with Ni or Ni(OH)(2)@Ni nanoparticles (NPs) were fabricated directly on Au electrodes by one-pot electrochemical approach. This facile, rapid, scalable, and green approach is based on the simultaneous co-reduction of GO and Ni2+ ions at ambient conditions from an aqueous solution without using specific reducing and any other protective agents. The as-prepared NiNP/ERGO could be easily converted into Ni(OH)(2)@NiNP/ERGO by electrochemical cycling in alkaline solutions. Characterization with field-emission scanning electron microscopy, transmission electron spectroscopy, X-ray diffraction, X-ray photoelectron spectroscopy, and Raman spectroscopy illustrated that the GO were successfully reduced into wrinkled and scrambled ERGO structures and decorated homogenously by very stable and well-separated NiNPs. The electrochemical performances of the as-prepared NiNP/ERGO and the activated Ni(OH)(2)@NiNP/ERGO electrodes were evaluated via cyclic voltammetry, galvanostatic charge/discharge, and electrochemical impedance spectroscopy. The as-prepared NiNP/ERGO electrodes exhibited a high specific capacity of 293 C g(-1) at 4Ag(-1). After cycling for 500 times, the surface of NiNPs on ERGO were converted into Ni(OH)(2)@NiNP/ERGO with a superior specific capacity of 785 C g(-1) at 4 A g(-1). A maximum capacity of 948 C g(-1) was obtained at 4 A g(-1) after 1500 cycles, and excellent cycling stability with 92% capacitiy retention was observed after more than 2000 additional cycles. The electrochemical performance of NiNP/ERGO and Ni(OH)(2)@NiNP/ERGO nanocomposites renders them as potential electrodes in supercapacitors. The present one-pot electrochemical strategy could also be used in the decoration of GO by other metal and metal hydroxides. (C) 2019 Elsevier Ltd. All rights reserved.