• 文献标题:   Carbide-bonded graphene coating of mold insert for rapid thermal cycling in injection molding
  • 文献类型:   Article
  • 作  者:   XIE PC, YANG HG, ZHAO YG, YU WX, CHENG LS, YANG WM, YAN H, TAN J
  • 作者关键词:   rapid thermal cycle, injection molding, carbidebonded graphene coating, silicon insert
  • 出版物名称:   APPLIED THERMAL ENGINEERING
  • ISSN:   1359-4311
  • 通讯作者地址:   Beijing Univ Chem Technol
  • 被引频次:   4
  • DOI:   10.1016/j.applthermaleng.2017.04.159
  • 出版年:   2017

▎ 摘  要

A novel carbide-bonded graphene coating on silicon insert was proposed to realize rapid thermal cycling (RTC) in injection molding. Continuous and dense carbon-bonded graphene coating was prepared on the surface of the silicon cavity through chemical vapor deposition. Serving as a thin-film resistance heater, the graphene coating was able to heat the mold cavity rapidly to above the glass-transition temperature of the polymer, even if the applied power source was of relatively low voltage. When the voltage was 240 V, the coating was heated up to 145.6 degrees C in a short period of 10 s, that is, the average and transient heating rates were able to be as high as 11.6 degrees C/s and 16.1 degrees C/s, respectively. This injection molding technique of RTC was successfully implemented to produce plate samples with uniform sizes in thickness (600 pm). The influence of RTC on weld line, internal stress, and replication fidelity was also investigated. Compared with conventional injection molding, our facile method was able to mold products with smaller weld mark, less internal stress, and better replication fidelity. The tensile strength and elongation at yield of the products were also enhanced by 37.77% and increased by 265.11%, respectively, with much less energy consumption. (C) 2017 Published by Elsevier Ltd.