▎ 摘　　要

In this study, a series of elastomeric nanocomposites based on specific amounts of polyamide6 (PA6)/chloroprene rubber (CR) blends which are compatibilized with ethylene propylene diene monomer-grafted-maleic anhydride (EPDM-g-MA) and different amounts of graphene oxide (GO) were prepared with melt mixing method. The effect of compatibilizer and reinforcement concentration in the PA6/CR blend matrix was investigated using theoretical and experimental analysis. Dispersion of nanoplatelets within rubber blend matrix was proven with transmission electron microscopy and field emission-scanning electron microscopy. The modified microstructure of samples showed the significant effect of EPDM-g-MA and GO on the size reduction of CR droplets in the PA6 continuous phase. The results from differential scanning calorimetry and dynamic mechanical thermal analysis revealed the effect of EPDM-g-MA and GO as an effective nucleating agent in PA6-enriched GO/CR (PA6EGO/CR). The findings obtained from thermogravimetric analysis displayed that the GO in the presence of an EPDM-g-MA as a compatibilizer can cause a higher thermal stability in PA6EGO/CR. From mechanical properties, by adding a compatibilizer to the PA6/CR blend, the tensile strength changed from 39.0 to 45.1, the Young's modulus altered from 522.2 to 716.0 and the elongation at break changed from 246.8 to 222.2. While incorporation of 5 phr of GO to the compatibilized blend, the tensile strength increased by 25.2%, the Young's modulus increased by 36.6% and the elongation at break decreased by 20%. The Christensen-Lo model used for analyzing the stiffness of PA6EGO/EPDM-g-MA/CR with emphasis on the influence of the interphase region to predict the effect of various loadings of GO and EPDM-g-MA of Young's modulus. The rheology and creep tests showed a significant effect of EPDM-g-MA and GO content on the rheology behavior of nanocomposites.