▎ 摘　　要

NOVELTY - The equipment has an inner winding chute (3) which is fixedly installed inside an upper surface of a device base (2), and an outer winding chute (4) is fixedly installed outside the upper surface of the device base. A circling gear (20) forms a gear with a sun gear (14), and the circling gear is fixedly installed at one end of a circling gear mounting shaft (21). A joint fixed support is fixedly installed on the upper surface of a lap mechanism mounting plate (11), and a reduction driving gear is fixedly installed in the middle of a driven friction coupling installation shaft. The right surface of a right sliding penetration plate is fixedly installed on the lower surface of a right sliding bottom plate. An end of the two friction guide shafts is fixedly installed at both ends of a bottom plate of the slide guide shaft, and the two friction guide shafts and the sliding holes at both ends of a friction power plate form a sliding fit. USE - Graphene shielded cable processing equipment. ADVANTAGE - The graphene shielding tape replacement plate is automatically reciprocated up and down under the drive of a motor, thus manpower is saved. The ring counting gear records the number of winding turns of the graphene shielding tape. The gears and connecting rods are used to adjust the transmission ratio of the pulley to reach the winding rate of the graphene shielding belt. DESCRIPTION OF DRAWING(S) - The drawing shows a schematic view of the graphene shielded cable processing equipment. Device base (2) Inner winding chute (3) Outer winding chute (4) Lap mechanism mounting plate (11) Sun gear (14) Circling gear (20) Circling gear mounting shaft (21)